FOR MORE INFORMATION CONTACT US : 3711/A,GIDC,PHASE-IV,vatva, Ahmedabad-382445. Phone:+91-79-25842503,
+91-79-2584 0845,
+91-9327015925
Fax: +91-79-25842503 Email:info@giplindia.com
Direct acting solenoid valve for domestic RO based water purification system
All G series valves manufactured by us are
being used as control valve in automatic water faucets,
urinal flushing system, auto taps and sensor taps. They
are used in electrical versions of such devices. Where
mains supply is used as power source.
Battery operated
sensor taps are convinient to install, lower on
maintenance, does not require any plumbing or electric
wiring at the location, hence it is ideal for new as well
as locations where conventional taps are to be replaced.
Since, electrical water valves require continous source
of power, it is not possible to make taps which operates
of low cost, low powered battery like 6 V lithium camara
battery or alkaline batteries.
General Imsubs offers wide range of water valves which
has magnetically latching operators, which requires only
60 mS pulse for latching and delatching. Hence offers very
long battery life.
Magnetically latching solenoid valve
Features
Low
cost.
Lower
operating time, 60 mS.
Wider
operating voltage range from 6 V DC to 4.8 V DC
Plastic
body for longer, trouble free operations.
Wire
leads for faster assembly.
Built
in removable and cleanable 0.40 mm apperture SS
filter.
Higher
mechanical life of more than 450 000 cycles.
Water
resistant plastic encapsulated coil.
How magnetically latching solenoid valve works
Magnetically latching solenoid valves employs magnets and electrical current to effect operations at expense of very little electrical power.
When electrical current is applied to coil, based on polarity of magnet and direction of current flow valve is latched or delatched.
When current polarity is reversed, valve latches if in delatched position and vice versa.
